WTCopy Manual for Futaba FP-7UGF radio

More
08 Jul 2017 21:13 #4129 by DeanChacon
DeanChacon created the topic: WTCopy Manual for Futaba FP-7UGF radio
OK, I know that this is a 20 year old radio, but it works fine at the moment, and I wanted to squeeze as much as possible out of my flying dollars. So I'm looking for a manual for it, scanned or not (If not, I can scan it and return the original) since my original has been lost.
This is the glider version of the Super-7 series with some tweaks for gliders. The thing I am looking for is how to set up a 4 servo wing - if the programming in the radio supports it. Recollection is that it was possible to mix the ailerons and elevators with the flaps so that the flaps would behave as flaperons for maneuvering, and then as flaps for landing with flap - elevator mixing.
ADChacon

Please Log in to join the conversation.

More
08 Jul 2017 21:51 - 08 Jul 2017 21:58 #4130 by JureZ
JureZ replied the topic: WTCopy Manual for Futaba FP-7UGF radio
see how close is this to your actual Tx

link to futaba site

also read this thread:
rcg thread link

and this article
article
Last Edit: 08 Jul 2017 21:58 by JureZ.

Please Log in to join the conversation.

More
09 Jul 2017 17:39 #4133 by DeanChacon
DeanChacon replied the topic: WTCopy Manual for Futaba FP-7UGF radio
I've seen the discussion in RCGroups. The problem is that the other transmitters only support one flap servo, or only flaperons but not ailerons, too (the flapperons used an aileron channels). The 7UGF supported two flap servos and two aileron servos.
But I just found my copy of the manual so I'm good to go.

Please Log in to join the conversation.

Time to create page: 0.304 seconds
Powered by Kunena Forum